Learn how to build a capacitor from a wine bottle

The first step in building a capacitor from wine bottles is make sure your bottles are empty and wrap aluminum around all the wine bottles you plan to use.

Next you will want to make sure you use tape to hold the aluminum on the bottles. You will have to makes holes in the top of the bottles to make sure nuts can fit through the top of the bottles and then you will need to make sure you use boiling hot water and then you will make sure you place salt in it, making sure you fill it up to where aluminum stops and then you will place a small amount of oil.

Next you will need to place your bolts into the water and place your caps on and put your nuts on area where the aluminum is left hanging. If you wish you can also place a metal plate on the bottom to hold your bottoms in place.

Last you will want to use caps to close your bottles and don't make the bottles too tight because they may need to be refilled again between 3 and 6 months. So now you have your capacitor that has been made from wine bottles.

Warning: This article is for informational use only and it's not something you should try doing.

Good Cheap Wine - Find the best inexpensive wines
Good Cheap Wine - Find the best low-cost wines